Chevrolet 1977 10 Series, Repair Manual, Page: 353 / 468

AUTOMATIC TRANSMISSIONS (400)7A-33
Fig. 7 A - 1 0 7 C - l n s t a l l i n g I n t e rm e d ia t e Clu tc h O ute r Race to
D ir e ct Clu tc h
12. Install the interm ediate clutch outer race with a
clock wise turning motion (fig. 7A-107C).
NOTE:
Interm ediate roller clutch is not released for the
CL and CZ models. The sprag assembly is released for
these models.
O uter race should not turn counter-clockwise after
installation. (See Figure 7A-108C).
13. Install intermediate clutch retainer and snap ring
Fig. 7A -1 08 C -ln te rm ed ia te Roller Clutch Rotation
Fig. 7 A - 1 0 9 C - l n s t a l l i n g I n t e rm e d ia t e C lu tch Re ta in er
(Fig. 7A-109C and 7A-1 IOC).
14. Place direct clutch assembly over center support and
air check operation of direct clutch (Fig. 7A-111C).
NOTE:
If air is applied through reverse passage, (right
oil feed hole) it will escape from direct clutch passage
(left oil feed hole). This is considered normal. Apply air
through left oil feed hole to actuate piston and move
direct clutch plates.
Fig. 7A-1 10C—Installing Intermediate Clutch Retainer Snap
Ring