Chevrolet 1977 10 Series, Repair Manual, Page: 317 / 468

AUTOMATIC TRANSMISSION (350)7A-33
J- 2 3 3 2 9
Fig. 7 A - 1 0 6 B ~ l n s t a l l i n g D ir e c t C lu tch Drum Bu s h in g
J-23327, compress return seat so spring retainer retaining
ring may be installed. Install output ring gear rear thrust
bearing in case.
4. Install output ring gear on output shaft.
5. Install reaction carrier to output ring gear front thrust
w asher (3 tangs) into output ring gear support.
6. Install output shaft assembly into case.
7. Install reaction carrier assembly into output ring gear
and shaft assembly.
8. Oil and install low reverse clutch steel reaction plates
and face plates, starting with a steel plate and alternating with
face plates. Install low and reverse clutch support retainer
(anti-clunk) spring.
N O TE: N otch in steel separator plates should be placed
toward bottom of case.
9. Install low and reverse clutch support assembly with
position of notch with low and reverse clutch support retainer
(anti-clunk) spring as shown on Figure 7A-107B.
10. Install low and reverse roller clutch inner race to sun
gear shell th ru st washer.
11. Install low and reverse clutch support to case snap
ring with anti-clunk spring between gap.
12. Install rear thrust washer and sun gear drive shell
assembly.
13. Install output carrier assembly.
14. Install input ring gear rear thrust washer.
15. Install input ring gear.
16. Install new input ring gear to output shaft snap ring.
CAUTION:
Do not over stress snap ring.
17. Install input gear front thrust washer.
18. Install direct clutch assembly, and special thrust
washer to forward clutch assembly.
19. Install clutch assemblies into case.
CAUTION:
Make certain forward clutch face plates
are positioned over input ring gear and the tangs
on direct clutch housing are installed into slots on
the sun gear drive shell.
20. Install interm ediate clutch overrun brake band.
21. Install interm ediate clutch pressure plate.
22. Oil and install face and steel interm ediate clutch
plates, starting with a face plate and alternating steel and face.
LOW A N D REVERSE
CLUTCH SUPPORT
LOW A N D REVERSE
CLUTCH SUPPORT
RETAINER SPRING
* .
***
[PUMP COVER TO DIRECT CLUTCH
SELECTIVE THRUST W ASHER
Fig. 7 A - 1 0 7 B -ln s ta llin g Low and Reverse Clutch Support
Assembly
Fig. 7 A - 1 0 8 B -P u m p Cover to Direct Clutch Selective Thrust
Washer