Chevrolet 1977 10 Series, Repair Manual, Page: 246 / 468

(200)7A-10 OVERHAUL MANUAL
Fig. 7 A-4 1 A - M a n u a l S h a ft and Park in g S h a ft Parts
5. Inspect reverse clutch seal and interm ediate band
anchor pin bores for damage.
6. Inspect vent assembly in case for damage. Do not
remove unless replacem ent is required.
7. Inspect for dam aged or stripped bolt holes. If any
threaded holes require heli-coils or equivalent, install these
to renew the threads.
8. T urn transm ission to vertical position, rear end up.
9. Inspect cooler line connectors for damage. Do not
remove unless replacing.
10. Inspect case bushing for damage or scoring.
11. If removed, install a new oil seal, using J-2 1426
(Fig. 7A-51A).
12. If vent was removed, apply Loctite Prim er "T", or
equivalent, to the outside diam eter of the vent that locates
in the case and Loctite 35, or equivalent, to the vent hole
in the case. Install vent, using a rubber or plastic hammer.
13. If removed, install new cooler line washer(s) and
connector(s); torque connector(s) to 20.0-27.0 N -m (15-20
ft. lbs.).
M A N U A L SHAFT AND PARKING PAWL
PARTS (Fig. 7A-52A)
Inspection
1. Align actuator rod tangs with hole in inside detent
lever and separate.
INSIDE DETENT LEVER
M ANUAL SHAFT
Fig. 7A-42A--Removing Manual Shaft Nut
Fig. 7A -43A -R em ovin g Manual Shaft from Case