Chevrolet 1977 10 Series, Repair Manual, Page: 233 / 468

ENGINE ELECTRICAL
6D-11
1 5 /1 6 " SOCKET
Fig. 6 D -9 C -ln s ta llin g P u lle y N ut
REASSEMBLY
1. Install rotor in drive end frame and attach spacer, fan,
pulley, washer, and nut.
2. Using adapter J-21501, insert an alien wrench into hex ,
shaped hole at end of shaft and torque the shaft nut to 40-50
ft. lbs. (fig. 6D-9C).
3. Install capacitor and retaining screw in slip ring end
frame.
4. Position brush holder and regulator assemblies in end
frame and install two retaining screws.
NOTE:
The two screws retaining the brush clips have
insulating washers over the top of the brush clips and
special insulating sleeves over the screw body above the
threads. If the third screw does not have an insulating
sleeve, it m ust not be interchanged with either of the
other two screws.
5. Position rectifier bridge to end frame. Install attaching
screw and the "B A T" term inal screw. Connect capacitor lead
to bridge.
6. Position diode trio on rectifier bridge term inal and
install screw attaching brush lead clip to brush holder.
CAUTION:
Insulating washer on the screw m ust be
assembled over top o f the connector.
7. Position stator in end frame. Connect stator leads to
rectifier bridge term inals and install attaching nuts.
8. Position slip ring end frame to drive end frame and
install four th ru bolts.
NOTE:
Remove tooth pick from brush holder at
opening in slip ring end frame before operating machine
on vehicle.
SPECIAL TOOLS
J - 2 1 5 0 1
PUU.Y
ADAPTER
Fig. 6D -10C~Special Tool