Chevrolet 1977 10 Series, Repair Manual, Page: 224 / 468

6D-2 OVERHAUL MANUAL
1. Drive Housing
2. Shift Lever Bolt,
Nut and Lock
Washer
3. Pin
4. Shift Lever
5. Solenoid Plunger
6. Solenoid Return Spring
7. Solenoid Case
8. Screw and Lock Washer
9. Grommet
10. Field Frame
11. Through Bolts
12. Thrust Collar
13. Snap Ring
14. Retainer
15. Overrunning Clutch As­
sembly
16. Armature
17. Braking Washing
18. Commutator End Frame
19. Brush Springs
20. Washer
21. Insulated Brush Holders
22. Grounded Brush Holders
23. Brushes
24. Screws
25. Field Coils
26. Insulators
27. Pole Shoes
28. Screws
Fig. 6 D -2 S --S ta rtin g M o to r P arts L a y o u t
d. Slide retainer and clutch from arm ature shaft.
5. Disassemble brush rigging from field frame.
a. Release "V" spring from slot in brush holder support.
b. Remove support pin.
c. Lift brush holders, brushes and spring upward as a
unit.
d. Disconnect leads from each brush.
e. Repeat operation for other set of brushes.
C L E A N IN G A N D IN S P E C T IO N
W ith the starting m otor completely disassembled except
for removal of field coils, the com ponent parts should be
cleaned and inspected as described below. Field coils need be
removed only where defects in the coils are indicated by the
tests described in this section.
1. Clean all starting m otor parts, but do not use grease
dissolving solvent for cleaning the overrunning
clutch,arm ature, and field coils since such a solvent would
dissolve the grease packed in the clutch mechanism and
would damage arm ature and field coil insulation.
2. Test overrunning clutch action. The pinion should