Chevrolet 10 Series 1970, Service Manual

Page: 135 / 671

BODY IB-57
Installation
1. Thoroughly clean inside of glass channels to rem ove
old glazin g rubber, rust, or other fo re ig n m atter,
2. P o sitio n new glazin g rubber (soapstone side away
fro m glass) around edge of glass. P r e s s glass with
glazin g rubber into lo w e r channel, then p ress upper
channel o v e r top of glass. Make sure channels are
fir m ly seated, then in sta ll two sm a ll screw s which
attach channels together.
3. If n ecessary, trim glazin g rubber at ends of channels
and along sides of channel each side of glass as
requ ired , sea l cracks at latch bracket.
4. In sert pivot stud of vent lo w e r channel into hole of
vent fra m e. Through sm all access hole at top of
door, in stall vent upper pivot screw . In stall three
screw s which attach bracket of vent channel to glass
d ivision channel just below vent latch.
5. In stall sp ecia l fla t w asher, nylon fric tio n bushing,
and fric tio n clam p on vent lo w e r channel pivot shaft.
NOTE: Make sure that tab on sp ecia l fla t
w asher is positioned p ro p e rly to act as a stop
of vent when it is in fu ll open position. Attach
fric tio n clam p to vent lo w e r fra m e with screw .
Tighten sc re w to obtain two to four pounds torque
while m oving vent window fro m a ten degree
to a fu ll-op en position. Use eith er a push or
pull type spring sca le positioned at re a r edge
of glass*
6. In stall access panel to inner side of door.
DOOR GLASS RUN CHANNEL REPLACEMENT
1. Rem ove door window as explained p revio u sly under
" D o o r Window G lass R eplacem ent.”
2. P u ll down on end of run channel at vent window, then
using a fla t blade s c r e w d r iv e r between channel and
door, detach channel retaining clips.
3. Make sure clip is detached at bottom of channel,
pull channel fro m door fra m in g and run channel
reta in er near bottom of door.
4. Install run channel into door fra m in g and channel
F ig . 133— Door W e a th e rs trip In s ta lle d
INSTALLING GLASS IN SEAL
G L A S S —— fcj
a
SEAL
w
PANEL
INSERT
T Y P I C A L
F ig . 134—In s e rt-T y p e Seat
F ig . 135—D riv e r's Seat Assem bly
CHEVROLET TRUCK SERVICE MANUAL