Chevrolet 10 Series 1970, Service Manual

Page: 120 / 671

BODY IB -42
P A D D E D
L IF T IN G S L IN G
F ig . 100—T y p ic a l L iftin g A rra ngem ents
Figu re 106, and on the le ft side the 45 d egree notch
is in stalled down and to the re a r. Tighten attaching
bolts fir m ly .
9. Tighten ste e rin g coupling clam p bolt 15 to 22 ft. lbs.
Connect speedom eter cable and a ll e le c tr ic connec­
to rs that junction with the cab -to-ch a ssis.
10. Connect a c c e le ra to r linkage and adjust as outlined
under Maintenance and A dju stm ents-E ngines. Con­
nect a ll ground straps.
11. Connect brake hoses and b leed brakes as outlined
under S ervice O peration s-B rak es.
12. Connect clutch fle x ib le line and bleed as outlined
under S e rv ic e O perations-C lutch.
13. Connect heater hoses and f i l l radiator. Connect bat­
te ry ground strap and in stall ra d ia tor g r ille
assem bly.
14. In stall bumper and bum per f i l l e r panel.
NOTE: Check tiltin g and locking action. A d­
just i f n ecessa ry fo llo w in g procedu re outlined
in this section.
F ig . 102— B racke t B olt Locations
TILTING M E C H A N IS M
O peration
To Raise Cab
(Refer to Figure 105)
NOTE: B e fo re tiltin g cab forw a rd , rem ove or
position loose p a rtic le s s a fely in cab, also place
tran sm ission shift le v e r in neutral and apply
hand brake.
1. C lose both doors of cab.
2. A t righ t re a r of cab rem o ve safety chain hook, then
pull lo w e r end of hold-down catch r e le a s e le v e r from
spring catch attached to cab.
3. W hile holding safety catch r e le a s e rod to the right,
ra is e hold-down re le a s e le v e r upward until hold-
down catch becom es disengaged and r e a r of cab
ra is e e fro m mount. T ilt cab com p letely forw a rd
until check link at right fron t mounting, locks cab
s a fe ly in fu ll- tilt position.
LEFT C A B
SU P P O R T
BRACKET
C H E C K
F ig . 101—A lig n in g B ra cke t B olt H oles F ig . 103—R ight Hand Support B racke t and C heck Link Fastenings
CHEVROLET TRUCK SERVICE MANUAL