Cerio OW-200N2, User Manual

Page: 134 / 290

User’s Manual
500mW eXtreme Power 11Na Outdoor Bridge
134
z On Demand – A connection to Internet is made as needed.
Notice: When Time Server is enabled at the “On Demand” mode, the “Reconnect
Mode” will turn out “Always on”.
z Manual – Click the “Connect” button on “WAN Information” in the Overview
page to connect to the Internet.
5.2.4.4 Idle Time : Time to last before disconnecting PPPoE session when it is idle.
Enter preferred Idle Time in minutes.
5.2.4.5 MTU : By default, it’s 1492 bytes. MTU stands for Maximum Transmission
Unit. Consult with WISP for a correct MTU setting.
5.2.5 DNS : Check “No Default DNS Server” or “Specify DNS Server IP” radial button as
desired to set up system DNS.
5.2.5.1 Primary : The IP address of the primary DNS server.
5.2.5.2 Secondary : The IP address of the secondary DNS server.
5.2.6 MAC Clone : The MAC address is a 12-digit HEX code uniquely assigned to
hardware as identification. Some ISPs require you to register a MAC address in order
to access to Internet. If not, you could use default MAC or clone MAC from a PC.
5.2.6.1 Keep Default MAC Address : Keep the default MAC address of WAN port
on the system.
5.2.6.2 Clone MAC Address : If you want to clone the MAC address of the PC,
then click the Clone MAC Address button. The system will automatically detect
your PC's MAC address.