BENSHAW RediStart MX3 Series, User Manual

Page: 70 / 238

Jump Code
4.6
Jump Code
At the beginning of each parameter group, there is a Jump Code parameter. By changing the value of this parameter and pressing
[ENTER], you can jump directly to any parameter within that group.
Restoring Factory Parameter Settings
4.7
Restoring Factory Parameter Settings
Go to the FUN group by pressing [MENU]. Scroll through to FUN 22- Miscellaneous Commands and press [ENTER]. Now set to
"Factory Rst" and press [ENTER]. The display will return to None but the parameters will be reset to the factory defaults.
Below is a list of the minimum parameters that will need to be set again.
FUN 05 (Rated RMS Voltage)
FUN 03 (CT Ratio)
I/O 01 - 08 (Digital Inputs)
I/O 10 - 15 (Relay Outputs)
z
NOTE: You must consult the wiring schematic for digital inputs and relay output configuration.
Resetting a Fault
4.8
Resetting a Fault
To reset from a fault condition, press [RESET].
Emergency Overload Reset
4.9
Emergency Overload Reset
To perform an emergency overload reset, press [RESET] and [DOWN] buttons together. This sets the motor overload content to 0.
LED Display
4.10
LED Display
The card mounted LED display can be used to access most of the parameters when the standard remote mounted display is not
connected. The LED parameter numbers (Pxx) are shown in the parameter table. See chapter 5.
62
4 - KEYPAD OPERATION