BENSHAW RediStart MX3 Series, User Manual

Page: 62 / 238

Introduction
4.1
Introduction
The MX
3
has a 2x16 character, back-lit LCD display/keypad that may be mounted remotely from the MX
3
control card. The remote
LCD keypad has menu, enter, up, down, left, start and stop/reset keys.
The display has keys such as [START], [STOP], and a [LEFT] arrow for moving the cursor around in the LCD display. Status indicators
provide additional information for the starter operation. Extended parameters are also added.
The remote keypad is NEMA 13 / IP65 when mounted directly on the door of an enclosure with the correct gasket.
Description of the LEDs on the Keypad
4.2
Description of the LEDs on the Keypad
The keypad provides three LED indicators in addition to the 2x16 character display. The LEDs provide starter status information.
z
NOTE:
By default, the [STOP] key is always active, regardless of selected control source (Local Source and Remote Source
parameters). It may be disabled though using the Keypad Stop Disable (I/O26) parameter. For more information refer to the Keypad
Stop Disable (I/O26) parameter on page 119.
54
4 - KEYPAD OPERATION
Figure 31 - Remote LCD Keypad
LED State Indication
STOP
On Stopped
Flashing Faulted
RUN
On Running and up-to-speed
Flashing Running and not up-to-speed (ramping, decelerating, braking etc).
ALARM Flashing Alarm condition exists. If condition persists, a fault occurs.
Table 18: Remote Keypad LED Functions