BENSHAW RediStart MX3 Series, User Manual

Page: 143 / 238

Passcode FUN 26
LCD Display
Description The MX
3
provides a means of locking parameter values so that they may not be changed. Once locked, the
parameters values may be viewed on the display, but any attempt to change their values by pressing the [UP]
or [DOWN] keys is ignored.
Viewing the Passcode parameter indicates whether or not the parameters are locked. If they are locked, the
Passcode parameter displays "On". If they are not locked, the Passcode parameter displays "Off".
To lock the parameters, press the [ENTER] key while viewing the Passcode parameter. This allows entry of a
4-digit number. Press the [UP] or [DOWN] keys and [ENTER] for each of the four digits. After entering the
fourth digit, the number is stored as the passcode and the parameters are locked.
Once parameters are locked, the same 4-digit number must be re-entered into the Passcode parameter in order
to unlock them. Any other 4-digit number entered will be ignored.
z
NOTE: To re-establish password protection after it has been cleared, the password must be entered again.
Fault Log FL1 - 9
LCD Display
Range FL1 – FL9
Description When a fault occurs, the fault number is logged in non-volatile memory. The most recent fault is in FL1 and
the oldest fault is in FL9.
Pressing [ENTER] toggles through the Starter data recorded at the time of the fault. See section 4.4.5 for
more information.
See Also
Appendix C - Fault Codes on page 205.
Event Recorder E01 - E99
Range E01 – E99
Description An event is anything that changes the present state of the starter. Some examples of events would be an
operation fault, a Start command, or a Stop command. The event recorder stores the last 99 events. When an
event occurs, the event number is logged in non-volatile memory. The most recent event is in E01 and the
oldest event is in E99.
See Also Appendix A – Event Codes on page 202.
Appendix C – Fault Codes on page 205.
135
6 - PARAMETER DESCRIPTION
FL1: Last Fault #
Fault Name
FUN: Passcode
26 Off