BENSHAW RediStart MX3 Series, User Manual

Page: 56 / 238

Remote LCD Keypad/Display
3.12
Remote LCD Keypad/Display
The display has a NEMA 13 / IP65 service rating. The display is available in 2 versions, a small display as P/N KPMX3SLCD and large
display as P/N KPMX3LLCD.
3.12.1 Remote Display
The LCD keypad is mounted remotely from the MX
3
Control via a straight through display cable which connects between the MX
3
RJ45
terminal and remote display's RJ45 terminal.
3.12.2 Installing Display
The remote display is installed as follows:
•
Install the gasket onto the display
•
Insert the display through the door cutout
•
Insert the mounting clips into the holes in each side of the display
•
Tighten the mounting clips until they hold the display securely in place. Torque requirements for the display screen is
0.7 NM (6.195 in lbs)
•
Plug the cable into the display connector on the MX
3
card. See figure 16 – control card layout on page 41 for the connector location
•
Route the cable through the enclosure to the display. Observe the wiring considerations as listed in section 3.4.3 on page 31
•
Plug the other end of the cable into the LCD display
48
3 - INSTALLATION
MX³ DISPLAY
GASKET
ENCLOSURE DOOR
MX³ DISPLAY CABLE
CLIP
CLIP
Figure 26: Mounting Remote Keypads