Benelli 502C, Owner'S Manual, Page: 114 / 559

3 - 5
Instrument and control functions
EN
3
Is the ABS diagnostic light shows one of
the following symptoms, one or more fau-
lts may have been occurred on the ABS
system.
•
The ABS diagnostic light does not
go on when the instrument panel is
switched on.
• The ABS diagnostic light will stay on
even when the vehicle exceeds the
speed of about 5 km/h.
In which event, take the motorcycle to an
authorized Benelli service centre.
It is important to point out the fact that
the ABS is not active when the light is
on, but the braking system will continue
working as a normal system not equipped
with ABS.
In this situation, a hard braking may lock
the wheels, causing slip and loss of stabili-
ty of the motorcycle.
Reserve fuel indicator
Comes on when approximately 3.2 litres
of fuel are left; in this case, fill up the tank
as soon as possible.
Anti-lock Brake System (ABS) warning
light
1.
ABS error:
whenever any fault is de-
tected and saved, the ABS diagnostic light
is on.
The ABS diagnostic light will turn off with
the next SHUTDOWN/ IGNITION of the in-
strument panel or when the vehicle exce-
eds the speed of about 5 km/h.
2. Disabled ABS mode: the ABS diagno-
stic light will flash once for about 1.30 se-
conds (short flashing).
3. By keeping the ABS button pressed for a
time of 3/30 seconds, the ABS diagnostic
light will flash once for about 0.30 se-
conds (short flashing).
4.
ABS activated:
When the instrument
panel is on, the ABS diagnostic light will
be on until the vehicle reaches the speed
of about 5 km/h. Once having exceeded
this speed, the diagnostic light will turn
off.
WARNING
Usually the ABS diagnostic light stays
on when the instrument panel is swi-
tched on and turns off when the vehicle
speed is above 5 km/h.
Speedometer
Push and hold the menu switch “SELECT”
for 3 seconds to enter the setting mode
“TOTAL KM”.
Speedometers Indicates the vehicle’s spe-
ed in km/h or mph. To pass from one to
the other, press the “RESET” button.
Total/partial kilometre counter
The total kilometre counter shows the to-
tal distance covered in kilometres.
Set in the mode instrumentation “TRIP A /
TRIP B” with the “SELECT” button.
The partial kilometre counter (TRIP A/TRIP
B) shows the distance covered since the
last reset in kilometres.
The partial kilometre counter can be used
to estimate the possible distance to cover
with a full tank of fuel. This information
may make it possible to schedule future
fuelling stops.
Transmission gear display
The transmission gear display shows the
selected gear.
This model is equipped with 6 gears.