Bard CROSSER, Instructions For Use Manual

Page: 4 / 117

4
Recommended separation distances between portable and
mobile RF communications equipment and the
F
LOW
M
ATE
®
Injector
The
F
LOW
M
ATE
®
Injector is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the
F
LOW
M
ATE
®
Injector can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters) and the
F
LOW
M
ATE
®
Injector as recom-
mended below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
W
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2.5 GHz
0.01 0.12m 0.12m 0.23m
0.1
P P
0.95m
1
P P
2.33m
10 3.69m 3.69m 9.49m
100
P P
23.33m
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
NOTE
$W0+]DQG0+]WKHVHSDUDWLRQGLVWDQFHIRUWKHKLJKHUIUHTXHQF\UDQJHDSSOLHV
NOTE
7KHVHJXLGHOLQHVPD\QRWDSSO\LQDOOVLWXDWLRQV(OHFWURPDJQHWLFSURSDJDWLRQLVDIIHFWHGE\DEVRUSWLRQDQGUHÀHFWLRQ
from structures, objects and people.
Warnings and Precautions
‡ 7KH F
LOW
M
ATE
®
Injector should only be used by individuals trained in percutaneous transluminal
angioplasty (PTA or PTCA).
‡ :$51,1*7RDYRLGWKHULVNRIHOHFWULFVKRFNWKLVHTXLSPHQWPXVWRQO\EHFRQQHFWHGWRDVXSSO\PDLQV
with protective earth.
‡ :$51,1*1RPRGL¿FDWLRQRIWKLVHTXLSPHQWLVDOORZHG
‡ :$51,1*5LVNRILQMXU\RUGHDWKWRRSHUDWRURUSDWLHQWFDQUHVXOWIURPXQDXWKRUL]HGPRGL¿FDWLRQWR
F
LOW
M
ATE
®
Injector.
‡ 1RWH3RVLWLRQ F
LOW
M
ATE
®
Injector to allow easy access to separable power cord during use.
‡ 3ULRUWRXVHWKH F
LOW
M
ATE
®
Injector, Foot Switch and all connection to power and the
C
ROSSER
™
Generator should be inspected for signs of damage. Never use damaged components. Contact the
manufacturer for a replacement or servicing.
‡ 7KH F
LOW
M
ATE
®
Injector is intended to be used with sterile normal saline only. Do not use the
F
LOW
M
ATE
®
Injector with contrast media.
‡ ([D]DUG'RQRWXVHLQWKHSUHVHQFHRIÀDPPDEOHDQHVWKHWLFV
‡ (OHFWULFD]DUG'RQRWDWWHPSWWRVHUYLFH
F
LOW
M
ATE
®
Injector or Foot Switch. Contact
manufacturer for servicing requirements.
‡ 7KH*URXQGLQJUHOLDELOLW\FDQRQO\EHDFKLHYHGZKHQWKHHTXLSPHQWLVFRQQHFWHGWRDQHTXLYDOHQW
receptacle marked Hospital Only or Hospital Grade. Grounding reliability cannot be achieved by
connecting the system to a Multiple Portable Socket-Outlets (MPSO – power strip) or extension cord.
‡ ,QWKHHYHQWRIDSRZHURXWDJHRUSRZHULQWHUUXSWLRQUXQWKURXJKWKHVHWXSSURFHGXUHV7KH F
LOW
M
ATE
®
Injector is designed to prevent operation following such events until the set-up procedures are repeated.
‡ 7KLV F
LOW
M
ATE
®
Injector generates, uses, and can radiate radio frequency energy and should only be
used and installed according to these instructions for use.
‡ 3RVLWLRQ)RRW6ZLWFKDQGFDEOHWRPLQLPL]HSRWHQWLDOWULSSLQJKD]DUG
‡ (QVXUH
F
LOW
M
ATE
®
Injector is securely mounted to a 5 caster IV pole with minimum caster diameter of
FPLQFKHVDQGDPLQLPXPEDVHGLDPHWHURIFPLQFKHVQRKLJKHUWKDQPHWHUV
inches) off the ground. The
F
LOW
M
ATE
®
Injector should not be mounted above the
C
ROSSER
™ Generator.
‡ 6KRXOGKLJKIUHTXHQF\YLEUDWLRQRUVDOLQHLQIXVLRQIDLOWRVWRSZKHQ)RRW6ZLWFKLVUHOHDVHGSRZHU
F
LOW
M
ATE
®
Injector/
C
ROSSER
™ Generator ‘OFF’ or unplug from power receptacle.
‡ 'RQRWUHXVHGLVSRVDEOHLWHPV'LVSRVHRISHUQRUPDOKRVSLWDOSURFHGXUHV
‡ $LU(PEROLVP5LVNWRPLQLPL]HDLUHPEROLVPULVNPDNHFHUWDLQWKHRSHUDWRULVWUDLQHGRQSURSHUV\ULQJH
loading techniques. Before injecting, be sure to clear air trapped in the syringe, infusion line and the
C
ROSSER
™ Catheter. Do not introduce the
C
ROSSER
™ Catheter into the patient until all air has been
purged from the infusion line and the
C
ROSSER
™ Catheter. A steady stream of saline exiting from the tip
of the
C
ROSSER
™ Catheter will be observed once all air has been purged.
d =
[ 3.5
V
1
]√
P
d =
[ 3.5
E
1
]√
P
d =
[ 7
E
1
]√
P
Required for Use
‡ $0HG5DGSDUW)74&RHXUSDUW&RU'H5R\DOSDUWPOSRZHULQMHFWLRQ
syringe (these part numbers are provided as a reference only, please verify the part numbers with the
manufacturer when placing any orders)
‡ $PLQLPXPRI´FPRIVWHULOHFRQWUDVWLQIXVLRQOLQH
‡ 1RUPDO6WHULOH6DOLQHUHFRPPHQGHGWREHUHIULJHUDWHGWRÛ)>Û&@SULRUWRORDGLQJ6HH
C
ROSSER ™ Catheter
Instructions for Use).
Out of Box Set Up / Installation
Note:
7KLVV\PERO,(&GHQRWHVWKH3RWHQWLDO(TXDOL]DWLRQ&RQGXFWRUWKDWLVGH¿QHGLQ,(&
3rd Edition, as
Conductor other than a Protective Earth Conductor or a neutral conductor, providing a direct
connection between electrical equipment and the potential equalization busbar of the electrical
installation.
Medically used rooms in most countries have no facilities for the use of detachable Potential
Equalization Conductors. If, however, the
F
LOW
M
ATE
®
Injector is installed in locations where Potential
(TXDOL]DWLRQ&RQGXFWRUVDUHXVHGWKHDSSURSULDWHUHTXLUHPHQWVKDYHEHHQVDWLV¿HG
1. Set up
F
LOW
M
ATE
®
Injector on a 5 caster IV pole not more than 1.3 meters above ground using the IV pole
FODPSVRQWKHEDFNRIWKH F
LOW
M
ATE
®
Injector. Position Foot Switch and cable to minimize potential tripping
KD]DUGDQGWLJKWHQWKHFODPSV¿UPO\WRSUHYHQWWKH F
LOW
M
ATE
®
Injector from sliding down the pole.
&RQQHFWSRZHUFRUGWREDFNRI F
LOW
M
ATE
® ,QMHFWRUDQGWKHQWRWKHZDOOUHFHSWDFOH0DNHVXUHWKHSRZHUFRUG
is positioned to minimize tripping hazard.
Note:
7RHQVXUHJURXQGLQJHI¿FLHQF\LVPDLQWDLQHGRQO\FRQQHFWWKH F
LOW
M
ATE
®
Injector to a ‘Hospital Grade’ or
‘Hospital Use’ receptacle.
3. Connect the Foot Switch Jumper Cable from the
F
LOW
M
ATE
® ,QMHFWRUVHH¿JXUH%WRWKH C
ROSSER ™
Generator (the Foot Switch connection; ).
4. Connect Foot Switch (supplied with the
C
ROSSER ™ Generator) to the
F
LOW
M
ATE
®
Injector, the connection is
ODEHOHGVHH¿JXUH&
5. The
F
LOW
M
ATE
®
Injector is now ready for operational use.
Note: It is recommended to test the
F
LOW
M
ATE
®
Injector by following the Operational Use instructions below
during training of the staff and prior to use in an actual procedure.
Operational Use
The
F
LOW
M
ATE
®
Injector has two modes of operation, Set Up and Run. In Set Up Mode the Turret is placed in the
upward position. This is the position where the syringe may be loaded, saline may be withdrawn into the syringe
and air is purged prior to placing the
F
LOW
M
ATE
®
Injector into Run Mode. When the Turret is rotated into the
downward position the
F
LOW
M
ATE
®
Injector is placed into Run Mode. Placing the Turret in between the two mode
ORFDWLRQVUHVXOWVLQDQLGOHFRQ¿JXUDWLRQDQGDÀDVKLQJ:KLWHVHWXSOLJKW1RPRWLRQRIWKHSXPSZLOOEHDOORZHG
in this state.
CAUTION! Do not rotate the Turret into Run Mode until proper Set Up has been completed.
Set Up Mode
1. The
F
LOW
M
ATE
® ,QMHFWRULVLQ6HW8SPRGHZKHQHYHUWKHWXUUHWLVLQWKHµXS¶SRVLWLRQ0DNHVXUHWKH
F
LOW
M
ATE
®
Injector is in the upward position before initiating the start up procedure.
2. Switch the unit ‘on’. The power switch is located by the ratings label of the stationary portion of the
F
LOW
M
ATE
®
Injector. The White
OLJKWQH[WWRWKH6HW8SLFRQVKRXOGEHÀDVKLQJ
2SHQ6\ULQJH/RFNLQJ0HFKDQLVPDQGLQVHUWDFRPSDWLEOHPOV\ULQJH6HH5HTXLUHG)RU8VHVHFWLRQ
above for a list of compatible syringes.
0DNHVXUHWKHV\ULQJHLVVHDWHGIXOO\LQWRWKHWXUUHWZLWKWKHÀDWHGJHRQWKHV\ULQJHÀDQJHDOLJQHGZLWKWKH
corresponding edge on the Turret.
Note: The
F
LOW
M
ATE
®
Injector is equipped with a syringe sensor. A compatible syringe must be seated correctly
for the
F
LOW
M
ATE
®
Injector to run properly.
:DUQLQJ'RQRWDWWHPSWWR¿OOWKHV\ULQJHE\UHPRYLQJWKHSOXQJHU7KH F
LOW
M
ATE
®
Injector is designed
to be set up and used only with a new syringe.
Insert 150ml syringe
Syringe