Barco Event Master E2 Lite, User Manual

Page: 87 / 330

R5909934 /00 E2 Lite and EC-40 87
Input adjustment panel > Main page
This menu is available in two versions according to the input type:
• DVI, HDMI and DisplayPort input types
• Name: Edits the name of the input configuration.
• Sync Status: Detects a good video sync.
• Video Status: Indicates if the Layer capacity is in
par with the input resolution.
• Format: The detected video format is shown here.
If Auto Acquire is unchecked below, the Wanted
video format is selected here from the drop-down
menu.
• Auto Acquire: Enables the auto acquire mode.
During acquisition, the system detects and
acquires the input type and resolution. Refer below
for details regarding this feature. Default is
On
• Colorspace: The detected colorspace is shown
here. In the event of a non-VESA standard source
the colorspace can be unmatched to the
processing. In this case a different colorspace can
be selected to accommodate the signal. Available
are:
- RGB, Full Range
- RGB, Reduced Range
- SMPTE, Full Range
- SMPTE, Reduced Range
• Connector Capacity: Each connector has the
option to accommodate different bandwidth
standards over its interface. This is referred to as:
- NONE The connector is turned off and cannot
accept any video, bandwidth of this connector
is freed up to be used by another connector.
Connector is grayed out in the graphic
representation. Connectors need to be
selected to NONE before DL or 4K can be
selected on others.
- SL S ingle L ink The connector can
accommodate a resolution up to 2048 x
1200@60Hz.
- DL D ual L ink The connector can accommodate
a resolution up to 2560 x 1600@60Hz.
Note: A dual link connector can also
accommodate a 3840 x 1080 or 2048 x 2160
signal, that is also available in the EDID list
once DL is selected for that input.
- 4K The connector can accommodate a
resolution up to 4K@30P.
Note: In order to accommodate a 4K@60
signal 2 or 4 connectors need to be used.
• Auto Acquire: Inputs auto acquire incoming video
as standard. If the setting is unchecked, only the
set or previously acquired signal will be valid
video.
• EDID
EM GUI orientation