Barco Event Master E2 Lite, User Manual

Page: 77 / 330

R5909934 /00 E2 Lite and EC-40 77
Image 6-12: Destination selected
The destination is selected. The destination is highlighted in blue.
Selecting a device or a destination in the Diagram allows the Adjustment area to display to display
the parameters corresponding to the device or destination. See Adjust Tab in the section
“ Configuration Menu > Adjustment area ” , page 78.
6.10 Configuration Menu > System modifier area
General
General parameters concerning the selected system are accessible in this area. The user can select the
system
’ s preset conflict mode, the native rate, and genlock mode.
Description
Image 6-13: System modifier area
• Preset Conflict: Mode — When using single layers conflicts can arise when a Preset Recall modifies a
source layer that is currently on Program. You may choose from three Preset Conflict Modes to resolve
these conflicts.
- Auto — The system performs the necessary actions to gracefully recall the Preset to Program.
- Force Recall — The system recalls the Preset directly to Program. Program is not protected.
- User Confirm — The system presents the user with a pop-up asking what to do when a conflict is
detected.
User Confirm options:
◦
Resolve – All Trans or Cut: Perform the necessary actions to resolve the conflict and perform an
All Trans or Cut to bring the Preset to Program.
◦
Resolve – Wait: Perform the necessary actions to resolve the conflict and wait for the user to press
the All Trans or Cut manually.
◦
Cancel: Cancels the entire Preset recall operation.
- Off — The system alerts the user with an error message about any Preset recall conflict, but it does not
present a pop-up menu for resolving the issue.
• Preset Conflict: Time(frame) is the amount of time the system uses when automatically performing an All
Trans.
EM GUI orientation