Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 187 / 342

BVS ID-M1280xF1-xx-xxx
english 13
Setting Description
Subnet mask You can set the subnet mask here.
Gateway If the IP address is static, the gateway can be set here. If the
gateway stays empty the camera may only be accessed within the
same subnet.
Restart Restart the BVS ID .
NOTE
Use different subnet masks, when using both network
interfaces (Gigabit Ethernet and Fieldbus). Otherwise you
can lose data packages because of unclear routing.

NOTE
The default Gateway is responsible for routing to and from
other networks. Even if both network ports are active,
usually only one gateway address is required.

NOTE
To apply changes in network settings, the BVS ID has to
be restarted.

NOTE
The above-mentioned parameters (Obtain an IP address automatically, IP, Subnet mask, and Gateway)
can be read and modified by means of ISDU (Indexed Service Data Unit). After parameter modification
using ISDU, the
BVS ID has to be restarted.

NOTE
It is recommended that the remote peer's network interfaces (PC or switch) are configured to use
auto-negotiation . If a fixed network speed is setup, then half-duplex mode should be chosen.
