Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 330 / 342

BVS ID-M1280xF1-xx-xxx
156 english
Command Value Device Action
0x81 (129) Application Reset – This reset is performed using IO-Link specification V1.1.2.
– Resets all parameters and device settings to default values (with the exception of
the
identification and tagging parameters)
– No reset of the configuration of the device variant
– Set DS-upload request (accept the data in the memory)
– No communication stop or restart
0x82 (130) Reset Factory Settings – This reset is performed using IO-Link specification V1.1.2.
– Reset all parameters and device settings to default settings (including
identification and
tagging parameters)
– Reset the configuration of the device variants to the default variant
– No DS-upload request
– No communication stop or restart
0xA5 (165) Maintenance Reset – Resets all resettable maintenance and service life parameters
for the user so that the next maintenance cycle can begin
Variant Configuration
ISDU
Name Inde
x Subin
dex Acc
ess Leng
ht Data
Type Data
Storag
e Default
Device Variant 0x0
055
(85) 0 R/
W 2
byte
s UINT16(
ENUM) No 1 (Default)
Device Variant
This parameter indicates which variant is currently set. The device variant can be changed either with this
parameter or by using the IO-Link compatibility mode. If this parameter is written, the device variant is not
changed immediately but instead after the
BVS ID is restarted. If the
device variant is changed via the IO-Link compatibility mode, the change in this parameter is visible immediately.
This parameter is not changed by a reset.
The following device variants are available::
1.
2.
After a variant changeover, an inconsistent configuration may occur because there is no automatic
changeover of parameters.
It is therefore recommended that the setup be done in the following order:
Variant setting
Perform factory reset or set valid parameters.
NOTE
