Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 224 / 342

BVS ID-M1280xF1-xx-xxx
50 english
•
•
•
Value
(dez) Value
(hex) Bit Name Description Reset to binary "0"
32768 00 80 15 System
Error This bit becomes active if
A critical temperature of 90 °C was
exceeded inside the device.
The inspection program could not be
imported. instead the standard
inspection program is set.
A critical error occurred while executing
the inspection program.
Automatically, as
soon as the system
error is resolved.
Example 1:
Status message from BVS ID to the client : 12 00 02 00 21 00
The status word 21 00 can be interpreted as: 0b 0010 0001 0000 0000. The 0th and the 5th bit are binary "1".
Therefore the status message indicates Ready and Waiting For Trigger .
Example 2:
Status message from BVS ID to the client : 12 00 02 00 20 01
The status word 20 01 can be interpreted as: 0b 0010 0000 0000 0001. The 5th of the low byte and the 0th bit
of the high byte (i.e. the 8th bit) are binary "1".
Therefore the status message indicates Ready and Trigger Error .
If the Ready bit is not set (binary "0") the error bits Input Data Error , Report Error and Trigger Overflow
are automatically set to binary "0" and are no longer changed. Those errors are accordingly not
reported by a status message in configuration mode. However, in case of a fatal system error, a status
message with the error bit
System Error is sent despite ready being binary "0". The other status bits
Waiting For Trigger and Simulation Mode also change their value in configuration mode and these
changes are reported by a status message.
NOTE
