Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 308 / 342

BVS ID-M1280xF1-xx-xxx
134 english
Name Inde
x Subin
dex Acc
ess Leng
ht Data
Type Data
Storag
e Default
Operating Hours
Saving Mode 0x0
074
(116
) 0 R/W 1
byte UINT8(E
NUM) Yes 0
Current Operating Hours
This parameter saves the value of the operating hours since the last commissioning in seconds.
Total Operating Hours
This parameter saves the value of the operating hours since the first commissioning in seconds.
Custom Operating Hours
This parameter saves the value of the operating hours since the last reset in seconds.
Operating Hours Saving Mode
The current storage behavior can be set..
Value Meaning Description
0x00 (0) Dynamic The first save operation is performed 1 minute after switching on; the storage
interval than doubles after every save operation. This is limited to a storage
interval of 12 minutes. The intervals are 1, 2, 4, 8, 12 minutes.
0x01 (1) Static Operating hours counters are stored every 12 minutes.
System Commands
Command Value Device Action
0x81 (129) Application Reset – Resets Custom Operating Hours to the default value.
0x82 (130) Reset Factory Settings – Resets Custom Operating Hours and Operating Hours
Saving Mode to the default value.
0xA5 (165) Maintenance Reset – Resets Custom Operating Hours to the default value.
Boot Cycle Counter
Description
After each start, the current Boot Cycle Counter is read from the non-volatile memory, incremented by 1 and
rewritten. In addition, a second Boot Cycle Counter is implemented that can be reset.
The maximum counter value that can be saved is 1,000,000 and, with a switch-on and switch-off every
12 minutes (with static counter), this means a service life of over 20 years. If switched on and off more
frequently or in the case of dynamic storage, the maximum storage time is reduced depending on the
application.
NOTE
