Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 320 / 342

BVS ID-M1280xF1-xx-xxx
146 english
•
•
Command Vlaue Device Action
0xC0 (192) Set Reference Orientation – Sets the reference orientation of the
actual position of the
BVS ID .
Responses: ACK: command successful, reference stored.
0x81 (129) Application Reset – Resets the inclination alarm configuration to the
default value of the firmware.
0x82 (130) Reset Factory Settings – Resets the inclination alarm configuration to the default
value of the firmware.
Events
Event
Code Event Type Event – Description – Remedy Device Status
0x8CD0
(36048) Warning Inclination alarm
→
Check installation.
1 – Maintenance-Required
This event shows that the BVS ID has lost its original position (taking the threshold value into account). The
mounting of the BVS ID should be checked sollte überprüft werden.
The BVS ID is still functional, but the measured values could be invalid, since the sensor.
Vibration
Description
The BVS ID makes available two vibration values, which provide valuable information for preventive
maintenance:
Total speed in [mm/s], which indicates the general machine state (lower frequency range)
Total acceleration in [g], which indicates the bearing state (higher frequency range)
This secondary device function allows the measurement of the vibration speed as a property of the physical
surroundings of a mechanical system. The primary goal is to detect significant changes or deviations of the
vibration. The
BVS ID sends messages if adjustable limit values are
exceeded.
Primary characteristics:
Output Value Vibration Level
Unit mm/s
Vibration frequency range 10…1000 Hz
Measurement range
1)
0…1770 mm/s
Detectable range of the vibration acceleration 0…16 g
The device cannot calculate the inclination until the reference position has been taught-in
NOTE
