Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 257 / 342

BVS ID-M1280xF1-xx-xxx
english 83
•
•
•
•
4.3.6 Commands and responses
The following responses are possible for all commands:
Status Beschreibung
NOK Error General error (e.g. command format error, internal error)
NOK Communication Abort The Job bit was removed before the handshake was finished
(abort by PLC)
NOK Invalid Command Invalid command code was set
NOK Busy The device is not ready, the command can't be processed at
the moment.
When setting an invalid command code, it will be responded with NOK Invalid Command.
Command Responses Meaning
Set Inspection ID OK The inspection program change has been
successfully completed.
NOK Busy The application is currently in a mode in
which requests can not be processed (ready
status is curently false).
NOK Inspection Error An error occured while loading the
inspection program due to one of the
following reasons:
Changing to an inspection program with
ID 0 is not possible via communication
interfaces.
The inspection program with the given
ID does not exist.
The maximum amount of inspection
programs has been exceeded, a change
is permitted until inspection programs
are being deleted.
The inspection program is corrupt or the
application ran out of memory during
load.
Get Inspection ID OK Inspection ID Response with the currently selected
inspection ID.
NOK Error During the processing of the Get Inspection
ID request an error occurred.
NOK Busy The application is currently in a mode in
which requests can not be processed (ready
status is curently false).