AudioCodes Mediant 3000, User Manual

Page: 806 / 872

User's Manual 806 Document #: LTRT-89729
Mediant 3000
Parameter Description
Web: Disconnect Call on
Busy Tone Detection
(ISDN)
EMS: Isdn Disconnect
On Busy Tone
[ISDNDisconnectOnBu
syTone]
Determines whether a call is disconnected upon detection of a busy
tone (for ISDN).

[0] Disable = (Default) Do not disconnect call upon detection of busy
tone.

[1] Enable = Disconnect call upon detection of busy tone.
Notes:

This parameter is applicable only to ISDN protocols.

IP-to-ISDN calls are disconnected on detection of SIT tones only in
call alert state. If the call is in connected state, the SIT does not
disconnect the calls. Detection of busy or reorder tones disconnects
the IP-to-ISDN calls also in call connected state.

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the calls in any call state.
Web: Disconnect Call on
Busy Tone Detection
(CAS)
EMS: Disconnect On
Detection End Tones
[DisconnectOnBusyTo
ne]
Determines whether a call is disconnected upon detection of a busy
tone.

[0] Disable = Call is not disconnected upon detection of a busy tone.

[1] Enable = (Default) Call is released upon detection of busy or
reorder (fast busy) tone.
Notes:

This parameter is applicable only to CAS protocols.

This parameter is also applicable to the IP-to-IP application.

This parameter can also be configured in a Tel Profile.
53.11.9 Tone Parameters
This subsection describes the device's tone parameters.
53.11.9.1 Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Tone Parameters
Parameter Description
[PlayHeldToneForIP2IP]
Enables playing a held tone to an IP-to-IP leg instead of placing it
on hold.

[0] = (Default) Disabled. The device interworks the re-INVITE
with 'a=inactive' from one SIP leg to another SIP leg.

[1] = Enabled. The device plays a held tone to the IP if it
receives a re-INVITE with 'a=inactive' in the SDP from the
party initiating the call hold. The held tone must be configured
in the CPT or PRT file.
Note: This parameter is applicable only to the IP-to-IP application.
Web/EMS: Dial Tone Duration
[sec]
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is played to an
ISDN terminal.
This parameter is applicable for overlap dialing when
ISDNInCallsBehavior is set to 65536. The dial tone is played if the
ISDN Setup message doesn't include the called number.
The valid range is 0 to 60. The default is 5.