AudioCodes Mediant 3000, User Manual

Page: 788 / 872

User's Manual 788 Document #: LTRT-89729
Mediant 3000
Parameter Description

For this parameter to take effect, a device reset is required.

This parameter is applicable only when the
SDHFbrGrp_Protected parameter is set to 1.
Web: Tributary KLM
Numbering
EMS: Fiber Group KLM
Numbering Scheme
[SDHFbrGrp_KLM_Numberin
g_Scheme]
Determines the KLM numbering scheme for VC/VT numbering on
STM-1/OC-3 interfaces.

[0] MLK (ETSI) = (Default) numbering scheme where M is run
first, then L, and last K. Typically used for SDH.

[1] LMK (GR-253) = Numbering scheme where L is run first,
then M, and last K. Typically used for SONET.

[2] KLM (Timeslots) = Numbering scheme where K is run first,
then L, and last M.
Once a scheme is selected, there is mapping of three variables
(K, L, and M) that identify VC/VT in the STM-1/OC-3 to a trunk
number (0 to 62, or 0 to 83):

K: TUG3 number (SDH) or STS-1 number (SONET)

L: TUG2 number (SDH) or VT group number (SONET)

M: TU number (SDH) or VT number (SONET)
In the Web interface, click the Go to the KLM Mapping Table
button to view the 'KLM Numbering Mapping Table page.
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only to Mediant 3000/TP-6310.

This parameter is relevant only when the parameter
TDMBusType is set to acFRAMERS (2), and
PSTNTransmissionType is set to Optical SONET or SDH
Transmission type (1).

For more information on KLM Numbering, see 'Trunk
Numbering (KLM Numbering)' on page
319 .
[SonetSdhMediumCircuitIde
ntifier] Defines the SDH/SONET circuit name.
Note: For this parameter to take effect, a device reset is required.
[SDHPmEnable] Enables performance monitoring for the fiber group.

[0] = Disables

[1] = Enable (default)
53.11.7 ISDN and CAS Interworking Parameters
The ISDN and CAS interworking parameters are described in the table below.
ISDN and CAS Interworking Parameters
Parameter Description
ISDN Parameters
Web: Send Local Time
To ISDN Connect
[SendLocalTimeToISD
NConnect]
Determines the device's handling of the date and time sent in the ISDN
Connect message (Date / Time IE) upon receipt of SIP 200 OK
messages.

[0] Disable = (Default) If the SIP 200 OK includes the Date header,
the device sends its value in the ISDN Connect Date / Time IE. If the
200 OK does not include this header, it does not add the Date / Time