AudioCodes Mediant 3000, User Manual

Page: 660 / 872

User's Manual 660 Document #: LTRT-89729
Mediant 3000
Parameter Description
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security level
authNoPriv(2), authentication protocol MD5, authentication text
password 'myauthkey', and ReadWriteGroup2.
Note: For a description of this table, see 'Configuring SNMP V3
Users' on page 95 .
53.2.5 Serial Parameters
The RS-232 serial parameters are described in the table below.
Serial Parameters
Parameter Description
[DisableRS232] Enables the device's RS-232 (serial) port.

[0] = (Default) Enabled

[1] = Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish
a serial communication with the device, refer to the
Installation Manual .
Note: For this parameter to take effect, a device reset is required.
EMS: Baud Rate
[SerialBaudRate]
Defines the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For this parameter to take effect, a device reset is required.
EMS: Data
[SerialData]
Defines the RS-232 data bit.

[7] = 7-bit

[8] = (Default) 8-bit
Note: For this parameter to take effect, a device reset is required.
EMS: Parity
[SerialParity]
Defines the RS-232 polarity.

[0] = (Default) None

[1] = Odd

[2] = Even
Note: For this parameter to take effect, a device reset is required.
EMS: Stop
[SerialStop]
Defines the RS-232 stop bit.

[1] = (Default) 1-bit (default)

[2] = 2-bit
Note: For this parameter to take effect, a device reset is required.
EMS: Flow Control
[SerialFlowControl]
Defines the RS-232 flow control.

[0] = (Default) None

[1] = Hardware
Note: For this parameter to take effect, a device reset is required.