AudioCodes Mediant 3000, User Manual

Page: 769 / 872

Version 6.6 769 Mediant 3000
User's Manual 53. Configuration Parameters Reference
Parameter Description

[A] T1 FRAMING F4 = T1 4-Frame multiframe.

[B] T1 FRAMING F12 = T1 12-Frame multiframe (D4).

[C] T1 FRAMING ESF = T1 Extended SuperFrame without
CRC6

[D] T1 FRAMING ESF CRC6 = T1 Extended SuperFrame with
CRC6

[E] T1 FRAMING F72 = T1 72-Frame multiframe (SLC96)

[F] T1 FRAMING ESF CRC6 J2 = J1 Extended SuperFrame
with CRC6 (Japan)
[FramingMethod_x] Same as the description for parameter FramingMethod, but for a
specific trunk ID (where
x denotes the Trunk ID and 0 is the first
Trunk).
Web/EMS: Clock Master
[ClockMaster]
Determines the Tx clock source of the E1/T1 line.

[0] Recovered = (Default) Generate the clock according to the
Rx of the E1/T1 line.

[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:

The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.

This parameter is applicable only to E1/T1 interfaces.
[ClockMaster_x] Same as the description for parameter ClockMaster, but for a
specific Trunk ID (where
x denotes the Trunk ID and 0 is the first
Trunk).
Note: This parameter is applicable only to E1/T1 interfaces.
Web/EMS: Line Code
[LineCode]
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1
spans.

[0] B8ZS = (Default) B8ZS line code (for T1 trunks only).

[1] AMI = AMI line code.

[2] HDB3 = HDB3 line code (for E1 trunks only).
[LineCode_x] Same as the description for parameter LineCode, but for a
specific trunk ID (where 0 denotes the first trunk).
[AdminState] Defines the administrative state for all trunks.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = Shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Notes:

For this parameter to take effect, a device reset is required.

When the device is locked from the Web interface, this
parameter changes to 0.

To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
[TrunkAdministrativeState_x Defines the administrative state per trunk, where x denotes the