AudioCodes Mediant 3000, User Manual

Page: 29 / 872

Version 6.6 29 Mediant 3000
User's Manual 2. Assigning the OAMP IP Address
2 Assigning the OAMP IP Address
The device is shipped with a factory default IP address for its operations, administration,
maintenance, and provisioning (OAMP) interface, as shown in the table below:
Default OAMP IP Address
IP Address Value
Private IP Address

TP-6310 or TP-8410 blade in Slot 1: 10.1.10.10

TP-6310 or TP-8410 blade in Slot 3: 10.1.10.11 (only for HA mode)
Subnet Mask
255.255.0.0
Default Gateway IP
Address 0.0.0.0
The default IP address can be used for initially accessing the device, using any of its
management tools (i.e., embedded Web server, EMS, or Telnet). Once accessed, you can
change this default IP address to correspond with your networking scheme in which the
device is deployed. After changing the IP address, you can re-access the device with this
new OAMPWhen operating with both voice and data IP address and start configuring and
managing the device as desired.
This section describes the different methods for changing the device's default IP address to
suit your networking environment:

Embedded command line interface (CLI) - see 'CLI' on page 32

Embedded HTTP/S-based Web server - see 'Web Interface' on page 29

Bootstrap Protocol (BootP) - see BootP/TFTP Server on page 31
Note: This section describes how to change the default OAMP IP address for
Mediant 3000 Simplex mode. For Mediant 3000 High Availability (HA) mode,
see Assigning an IP Address for Mediant 3000 HA on page
34 .
2.1 Web Interface
The procedure below describes how to assign an OAMP IP address using the Web
interface.

To assign an OAMP IP address using the Web interface:
1. Disconnect the network cables (if connected) from the device.
2. Connect one of the Ethernet ports located on the RTM-8410 or RTM-6310 directly to
the network interface of your computer, using a straight-through Ethernet cable.