AudioCodes Mediant 3000, User Manual

Page: 32 / 872

User's Manual 32 Document #: LTRT-89729
Mediant 3000

To assign an IP address using BootP/TFTP:
1. Start the AcBootP utility.
2. Select the Preferences tab, and then set the 'Timeout' field to "50".
3. Select the Client Configuration tab, and then click the Add New Client button.
Figure 2-4: BootP Client Configuration Screen
4. Configure the following fields:
•
‘Client MAC’: Enter the device's MAC address. The MAC address is printed on
the label located on the underside of the device. Ensure that the check box to the
right of the field is selected in order to enable the client.
•
'Client IP’: Enter the new IP address (in dotted-decimal notation) that you want to
assign the device.
•
‘Subnet’: Enter the new subnet mask (in dotted-decimal notation) that you want to
assign the device.
•
‘Gateway’: Enter the IP address of the Default Gateway (if required).
5. Click Apply to save the new client.
6. Physically reset the device by powering it down and then up again. This enables the
device to receive its new networking parameters through the BootP process.
2.3 CLI
The procedure below describes how to assign a VoIP OAMP IP address, using CLI.
Notes:
•
For HA mode, this method changes only the local, private IP addresses
of the blades. These IP addresses are used for maintenance and fallback
in case of a major problem preventing the device from operating in HA
mode.
•
To operate in HA mode, the “global” IP addresses must be configured in
the Multiple Interface table.