AudioCodes Mediant 3000, User Manual

Page: 198 / 872

User's Manual 198 Document #: LTRT-89729
Mediant 3000
then click the Quality Of Experience link; the Quality Of Experience page appears.
3. Click the Add button; the following dialog box appears:
Figure 13-16: Quality of Experience Page - Add Record Dialog Box
The figure above shows value thresholds for the MOS parameter, which are assigned
using pre-configured values of the Low Sensitivity profile. In this example setting, if the
MOS value changes by 0.1 (hysteresis) to 3.3 or 3.5, the device sends a report to the
SEM indicating this change. If the value changes to 3.3, it sends a yellow state (i.e.,
medium quality); if the value changes to 3.5, it sends a green state.
4. Configure the parameters as required. See the table below for a description of each
parameter.
5. Click Submit to apply your settings.
Quality of Experience Parameter Descriptions
Parameter Description
Index
[QOERules_RuleIndex]
Defines the table index entry. Up to four table row entries can be
configured per Media Realm.
Monitored Parameter
[QOERules_MonitoredParam]
Defines the parameter to monitor and report.

[0] MOS (default)

[1] Delay

[2] Packet Loss

[3] Jitter

[4] RERL
Direction
[QOERules_Direction]
Defines the monitoring direction.

[0] Device Side (default)

[1] Remote Side
Profile
[QOERules_Profile]
Defines the pre-configured threshold profile to use.

[0] No Profile = No profile is used and you need to define the
thresholds in the parameters described below.

[1] Low Sensitivity = Automatically sets the thresholds to low
sensitivity values. Therefore, reporting is done only if changes
in parameters' values is significant.

[2] Default Sensitivity = Automatically sets the thresholds to a
medium sensitivity.