AudioCodes Mediant 3000, User Manual

Page: 128 / 872

User's Manual 128 Document #: LTRT-89729
Mediant 3000
Parameter Description
The address of the host/network you want to reach is determined by an AND operation that is
applied to the fields 'Destination IP Address' and 'Prefix Length'. For example, to reach the network
10.8.x.x, enter 10.8.0.0 in the 'Destination IP Address' field and 16 in the 'Prefix Length'. As a result
of the AND operation, the value of the last two octets in the 'Destination IP Address' field is ignored.
To reach a specific host, enter its IP address in the 'Destination IP Address' field and 32 in the
'Prefix Length' field.
Gateway IP Address
[StaticRouteTable_Gateway]
Defines the IP address of the router (next hop) used for traffic
destined to the subnet/host as defined in the 'Destination IP
Address' / 'Prefix Length' field.
Note: The Gateway address must be in the same subnet as the
IP address of the interface over which you configure this static
routing rule.
Metric Defines the number of hops needed to reach the specified
destination.
Note: The recommended value for this parameter is 1. This
parameter must be set to a number greater than 0 for the routing
rule to be valid. Routing entries with Hop Count equals 0 are local
routes set automatically by the device.
Interface Name
[StaticRouteTable_InterfaceN
ame]
Assigns a network interface through which the 'Gateway IP
Address' is reached. This is the string value as configured for the
network interface in the 'Interface Name' field of the Multiple
Interface table (see 'Configuring IP Network Interfaces' on page
116 ).
Note: The IP address of the 'Gateway IP Address' field must be in
the same subnet as this interface's IP address.
Status Read-only field displaying the status of the static IP route:

"Active" - routing rule is used ny the device.

"Inactive" - routing rule is not applied. When the destination IP
address is not on the same segment with the next hop or the
interface does not exist, the route state changes to "Inactive".
11.4.1 Interface Column
This example describes the configuration of static IP routing rules.
Note: The Interface Address family must be coherent with the Routing Rule
Address family. IPv4 interfaces cannot be selected in an IPv6 routing rule,
and vice versa.
1. Configure network interfaces in the Multiple Interface table, as shown below:
Configured Network Interfaces in Multiple Interface Table
Index
Applica
tion
Type
Interface
Mode
IP Address
Prefix
Length
Gateway
VLAN
ID
Interface
Name
0 OAMP
IPv4
Manual
192.168.0.2 16 192.168.0.1 501 Mng