AudioCodes Mediant 3000, User Manual

Page: 723 / 872

Version 6.6 723 Mediant 3000
User's Manual 53. Configuration Parameters Reference
Parameter Description

The first retransmission is sent after 500 msec.

The second retransmission is sent after 1000 (2*500) msec.

The third retransmission is sent after 2000 (2*1000) msec.

The fourth retransmission and subsequent retransmissions until
SIPMaxRtx are sent after 4000 (2*2000) msec.
Web: SIP T2
Retransmission Timer
[msec]
EMS: T2 RTX
[SipT2Rtx]
Defines the maximum interval (in msec) between retransmissions of SIP
messages (except for INVITE requests).
The default is 4000.
Note: The time interval between subsequent retransmissions of the
same SIP message starts with SipT1Rtx and is multiplied by two until
SipT2Rtx.
Web: SIP Maximum RTX
EMS: Max RTX
[SIPMaxRtx]
Defines the maximum number of UDP transmissions of SIP messages
(first transmission plus retransmissions).
The range is 1 to 30. The default is 7.
Web: Number of RTX
Before Hot-Swap
EMS: Proxy Hot Swap Rtx
[HotSwapRtx]
Defines the number of retransmitted INVITE/REGISTER messages
before the call is routed (hot swap) to another Proxy/Registrar.
The valid range is 1 to 30. The default is 3.
Note: This parameter is also used for alternative routing. If a domain
name in the Outbound IP Routing Table or SBC IP-to-IP Routing table
is resolved into two IP addresses, and if there is no response for
HotSwapRtx retransmissions to the INVITE message that is sent to the
first IP address, the device immediately initiates a call to the second IP
address.
SIP Message Manipulations Table
Web: Message
Manipulations
EMS: Message
Manipulations
[MessageManipulations]
This table parameter defines manipulation rules for SIP header
messages.
The format of this parameter is as follows:
[ MessageManipulations ]
FORMAT MessageManipulations_Index =
MessageManipulations_ManSetID,
MessageManipulations_MessageType,
MessageManipulations_Condition,
MessageManipulations_ActionSubject,
MessageManipulations_ActionType,
MessageManipulations_ActionValue, MessageManipulations_RowRole;
[\MessageManipulations ]
For example, the below configuration changes the user part of the SIP
From header to 200:
MessageManipulations 1 = 0, Invite.Request, , Header.From.Url.User,
2, 200, 0;
Note: For a detailed description of this table, see 'Configuring SIP
Message Manipulation' on page 250 .
Message Policy Table
Web: Message Policy
Table
[MessagePolicy]
This table parameter configures SIP message policy rules for blocking
(blacklist) unwanted incoming SIP messages or allowing (whitelist)
receipt of desired messages.The format of this parameter is as follows:
[MessagePolicy]
FORMAT MessagePolicy_Index = MessagePolicy_Policy,
MessagePolicy_MaxMessageLength,