AudioCodes Mediant 3000, User Manual

Page: 31 / 872

Version 6.6 31 Mediant 3000
User's Manual 2. Assigning the OAMP IP Address
5. Change the default IP address to one that corresponds with your network:
a. Open the Multiple Interface Table page ( Configuration tab > VoIP menu >
Network submenu > IP Settings ).
Figure 2-3: IP Settings Page (Single Network Interface)
b. Select the 'Index' radio button corresponding to the "OAMP + Media + Control"
application type, and then click
Edit .
c. Change the IP address, subnet mask, and Default Gateway IP address to
correspond with your network IP addressing scheme.
d. Click Apply , and then click Done to validate your settings.
6. Save your settings to the flash memory with a device reset (see Resetting the Device
on page
517 ).
7. Disconnect the computer from the device and then reconnect the device to your
network.
2.2 BootP/TFTP Server
You can assign an IP address to the device using BootP/TFTP protocols. This can be done
using the AudioCodes AcBootP utility (supplied) or any standard compatible BootP server.
Note: You can also use the AcBootP utility to load the software file (.cmp) and
configuration file (.ini). For a detailed description of the AcBootP utility, refer
to
AcBootP Utility User's Guide .