Altigen AltiWare ACM 5.1, Administration Manual

Page: 169 / 454

Chapter 12: Trunk Configuration
AltiWare ACM 5.1 Administration Manual 155
SIP Trunk Properties
Traditionally telecom trunks are from your local carrier’s PSTN switch and the dial tone
is provided via either analog trunks or T1/PRI digital trunks. A new type of service called
“IP Dial Tone,” which allows you to dial a long distance call at a lower rate, is available.
IP Dial Tone is delivered through your IP data network, and the service provider can be
anywhere in the world, as long as the VoIP data packets can be routed properly.
If you have SIP-based IP dial tone service from an Internet Telephony Service Provider
(ITSP), you need to configure SIP trunk channels to connect the service. Before you
start, note the following:
•
An AltiGen SIP Trunking channel is licensed. You need to buy and register a license
to be able to configure this option.
•
AltiGen does not guarantee the voice quality of the SIP dial tone coming from your
service provider. You need to work with your data service and SIP trunking service
provider to make sure adequate QoS is provisioned for your WAN service.
•
AltiGen does not guarantee SIP trunk implementation will work with all SIP Dial Tone
service providers. You need to verify that your SIP Dial Tone service provider
supports the following:
•
G.711, G.723.1, G.729 codec
•
RFC 2833 for DTMF tone delivery
•
SIP MD5 authentication with SIP registration
•
If AltiServ is behind NAT, verify that your SIP SP can support this configuration.
When subscribing to SIP Dial Tone service, typically your service provider will provide
you with the information required in the configuration dialog box shown in Figure 5 on
page 156. Enter these service parameters to each SIP trunk channel configuration
individually.
Note: This is signal only trunks. Make sure you have enough IP resource boards to cover
your needs.
Important: You need to add the SIP Trunk service provider’s IP address to the IP Device
Range in AltiEnterprise Manager and select the proper codec profile for this
service. See “Assigning Codec Profiles to IP Addresses” on page 330. Failure
to do this step may cause no voice path, even if the SIP Trunk channel shows
the call is connected.
Configuring a SIP Trunk
To open a trunk configuration dialog box for a SIP trunk, do one of the following:
•
In the Trunk Configuration window, select a SIP trunk type, click the Trunk
Properties button, then click the SIP Trunk Configuration button.
•
In the Board View window, double-click a SIPSP board type, click the Board
Configuration button, then click the SIP Trunk Configuration button.