Alcatel-Lucent 7750 SR OS, Interface Configuration Manual

Page: 282 / 444

Configuration Commands
Page 282 7750 SR OS Interface Configuration Guide
• Out of Cell Delineation (OCD) event count. The OCD event count is described in RFC 2515,
Definitions of Managed Objects for ATM Management . Note that multiple events occurring
within a second will be counted as 1 event for ASAP MDAs as a result of a hardware limit.
• Loss of Cell Delineation defect/alarm. The LCD defect/alarm is defined in RFC 2515, Defini-
tions of Managed Objects for ATM Management . When a path is in an LCD defect state, the
path’s operational status will be down. When a path exits the LCD state, the path’s operational
status will change to up (assuming nothing else causes the path to stay down). A trap is raised to
indicate the LCD status change. Also, a P-RDI is sent to indicate the defect to the remote end.
The no form of this command restores the default.
Default bcp-null
atm — Specifies the encapsulation on the port is ATM.
bcp-null — When selected, this keyword specifies that only a single service is configured on this
channel and IEEE 802.1Q tags are not used as a service delimiter. Any IEEE 802.1Q tags
encountered are regarded as part of the customer payload and transparently forwarded. When
bcp-null encapsulation is specified, the PPP Bridge Control Protocol (BCP) is activated and all
packets on this access port will be encapsulated in accordance with the BCP protocol.
bcp-dot1q — When selected, this keyword specifies that ingress frames carry IEEE 802.1Q tags and
the tags are used as service delimiter. Any untagged packets are silently discarded with
exception of protocol specific packets. When bcp-dot1q encapsulation is specified, the PPP
Bridge Control Protocol (BCP) is activated and all packets on this access port will be
encapsulated in accordance with the BCP protocol.
ipcp — Ingress frames are encapsulated according to the IP Control Protocol. When ipcp
encapsulation is specified, the PPP IP Control Protocol will be activated and only packets that
comply with IPCP encapsulation are processed; others are silently discarded.
ppp-auto — (Network mode) Enables PPP on the associated port/channel. The activation of ipcp
and mplscp is automatically enabled depending on the protocol configuration. This encap type is
only valid on ports/channels in network mode.
frame-relay — Enables frame relay on the associated port/channel.
wan-mirror — The port is used for mirroring of frame-relay and POS ports. On these ports, no link
management protocol will run.
cisco-hdlc — Monitors line status on a serial interface by exchanging keepalive request messages
with peer network devices.
cem — On circuit emulation CMAs and MDAs, only the cem encap-type is supported. All other
values are blocked with an appropriate warning. The cem encap-type is not supported on other
CMAs and MDAs and are blocked with an appropriate warning.