Agilent Technologies B1542A, User Manual

Page: 62 / 162

3- 14 Agilent B1542A User’s Guide, Edition 4
Performing System Setup and Compensation
Compensation
6. Measure the delay time between the gate pulse and the drain pulse as shown
below.
a. Confirm the setup. Or connect the cables as shown in the connection
diagram window. Then disconnect the SMA(m)-(m) adapter from the
SMA(f)-(m)-(f) adapter at the end of the gate connection cable and connect
the drain connection cable to the SMA(f)-(m)-(f) adapter.
b. Click OK on the connection diagram window to continue the setup. This
opens a message box to confirm the execution of delay time measurement.
Click Cancel to cancel the setup.
c. Click OK on the message box to perform the delay time measurement. This
starts the measurement and opens a dialog box to show the measurement
status. After the measurement, the Compensation action is completed.
Click Cancel to cancel the setup.
Figure 3-6 Gate to Drain Delay Time Measurement Setup for Pulse IV Test System
'62
608
7ULD[LDOFDEOH
'LYLGHU
%1&P7ULD[IDGDSWHUIORDWLQJJXDUG
60$IPIDGDSWHU
60$FDEOHP
%LDV7
WR75,**(5287
WRLQSXWFKDQQHOIRUJDWH WRLQSXWFKDQQHO
IRUGUDLQ
7HUPLQDWRU
WR608)RUFH
IRUGUDLQYROWDJH
WR$8;7ULJ,Q
3*8
%1&FDEOH
5)
5)'&
'&
'87FDEOHP
WRRXWSXWFKDQQHO
IRUJDWHSXOVH
60$FDEOHP
8VH%1&P60$IDGDSWHUIRUSXOVHJHQHUDWRU
8VH%1&P60$IDGDSWHUSUHFLVLRQW\SHIRURVFLOORVFRSH
60$FDEOHP