AG-BAG LX1214, Operator'S Manual

Page: 74 / 276

3 - CONTROLS AND INSTRUMENTS
Outside cab end up — down switch
DANGER
Crushing hazard!
Keep away from the lift jack pad when you lower the jack. Make sure that your body is clear of the
area underneath the lift jack pad.
Failure to comply will result in death or serious injury.
D0197A
Machine Up or Down: This control is used to lift or lower
the cab end of the bagger by lowering or raising the lift
jack at the cab end. It is located on the frame next to the
inoculant tank.
RAIL16GEN0078AA
9
Use this control (1) to lift the cab end of the bagger. Lift
the bagger up only as far as needed to rotate the wheels
or to hitch to a tow vehicle. This switch is spring loaded
and will return to the center (Off) position when released.
Push the switch up to lower the lift jack (raise machine).
Push the switch down to raise the lift jack (lower machine).
Be sure to raise the lift jack completely before moving the
bagger and during bagging operation.
RAIL16GEN0078AA
10
Battery disconnect switch
The battery disconnect switch (1) is located above the
signal lights (2) on the engine frame. Be sure the switch
is in the “ON” position before attempting to operate the
bagger. The switch can remain in the “ON” position unless
there is a power drain on the batteries, then turn the switch
to the “OFF” position when the bagger is not being used,
this will disconnect the batteries from the bagger electrical
system.
RAIL16GEN0079AA
11
3-36