AG-BAG LX1214, Operator'S Manual

Page: 60 / 276

3 - CONTROLS AND INSTRUMENTS
Brake pressure adjustment switches (cab &
engine end)
The brake pressure adjustment switches for the cab end
(1) and engine end (2) are located on the right side corner
post.
The switches are used to increase (3) or decrease (4)
the brake pressure during bagging. Press the top of the
required switch to increase the pressure . When released
the switch will return to the center off position. Press the
bottom of the required switch to decrease the pressure.
RAIL16GEN0042AA
5
The brake pressure for the cab end (1) and the engine
end (2) brakes are shown on the display.
RAIL16GEN0052AA
6
Two wheel drive/four wheel drive switch
The two wheel drive/four wheel drive is a two position
rocker switch
(1) located on the right side corner post.
Push the top of the switch in for two wheel drive (2) . In
this position only the engine end wheels will drive. Two
wheel drive is used in the transport drive mode only and
allows the bagger to travel at a higher ground speed than
four wheel drive. When in two wheel drive, ONLY drive on
smooth level surfaces and Do Not make sharp turns.
Push the bottom of the switch in for four wheel drive (3)
. In this position all four wheels will be driving. Use this
position for bagging mode and trailer mode for driving on
to and off of a trailer.
RAIL16GEN0042AA
7
Drive/align switch
The drive/align switch (1) is a two position rocker switch
located on the right side corner post.
When switching drive modes, the wheels may need some
realignment to complete the mode change. In this case
press the top
(2) of the switch and then realign the wheels
as called for on the display panel. Wheel drives will not
function with switch set to align.
Push the bottom (3) of the switch in after alignment is
complete to drive the unit.
RAIL16GEN0042AA
8
3-22