AG-BAG LX1214, Operator'S Manual

Page: 140 / 276

6 - WORKING OPERATIONS
6. Route the cable (1) under the first pulley (2) on the
cylinder rod end (3) . From the first pulley route the
cable over the top of the first pulley (4) on the cylinder.
Repeat this process for the remaining pulleys.
RAIL16GEN0274AA
7
RAIL16GEN0248AA
8
7. Insert the end of the cable through the cable anchor
tube
(1) .
8. Slide the cable through the sleeve (2) .
9. Unravel the cable and wrap around the knob core.
Keep the knob core halves
(3) flush.
10. Tap the sleeve down on to the knob core halves with
a hammer.
11. Manually pull the cable tight from the outside.
12. Mark the cable as close to the fair lead as possible
(outer edge of pivot assembly).
13. Extend the cable 122 cm ( 48 in ) . Pull the cable while
extending.
14. Cut the cable at the mark.
15. Slide the cable through the center of the anchor. In-
stall the cable stop on to the cable.
16. Pull on the anchor to secure the cable stop in the
nose of the anchor.
17. Retract the anchors. The anchors should be tight in
the sockets.
18. Repeat this procedure to replace the other cable.
RAIL16GEN0250AA
9
RAIL16GEN0249AA
10
6-34