AG-BAG LX1214, Operator'S Manual

Page: 128 / 276

6 - WORKING OPERATIONS
8. Remove the guard (1) over the chains at the driven
end of the rotor on the feed table side. This is to ac-
cess the three allen flat head bolts
(2) (in line with the
rotor) that hold the tunnel to the frame. Remove all
three bolts. Save all hardware for reassembly. Early
production had flat head bolts,
(2) current production
has hex head bolts (3) .
RAIL16GEN0097AA
59
RAIL16GEN0096AA
60
9. Remove the nine bolts (1) from each side of the tunnel
(between the tunnel support pipes) (2) The bottom four
on each side have spacers to the inside. Save all
hardware for reassembly. Lower four bolts shown.
RAIL16GEN0099AA
61
10. Remove the wire harness (1) from the limit switch (2)
located on the tunnel side behind the clean out plate.
The limit switch can remain with the tunnel.
RAIL16GEN0100AA
62
6-22