AG-BAG LX1214, Operator'S Manual

Page: 204 / 276

7 - MAINTENANCE
Lubricate beater bar bearings
NOTE: Use NEW HOLLAND AMBRA GR-9 MULTI-PURPOSE GREASE on all fittings.
On the cab side of the hopper, locate the shield (1) cov-
ering the lower beater bar drive. Clean off the grease
fitting through the access hole
(2) in the shield. Attach
the grease gun. Wipe up excess grease. Grease this
bearing twice each bag, two pumps at the beginning of
the bag and two pumps halfway through the bag. Do
not over grease. It is better to give the bearings smaller
amounts of grease more often, than large amounts of
grease.
RAIL16GEN0172AA
1
Locate the lower beater bar bearing (3) on the engine
side of the hopper. Wipe off the fitting before attaching
the grease gun. Wipe up excess grease. Grease this
bearing twice each bag, two pumps at the beginning of
the bag and two pumps halfway through the bag. Do
not over grease. It is better to give the bearings smaller
amounts of grease more often, than large amounts of
grease.
RAIL16GEN0173AA
2
On the engine side of the hopper, locate the drive (1)
for the upper beater bar. Clean off the grease fitting
on the bearing
(2) . Attach the grease gun. Wipe up
excess grease. Grease this bearing twice each bag,
two pumps at the beginning of the bag and two pumps
halfway through the bag. Do not over grease. It is better
to give the bearings smaller amounts of grease more
often, than large amounts of grease.
RAIL16GEN0174AA
3
Locate the upper beater bar bearing (3) on the cab
side of the hopper. Wipe off the fitting before attaching
the grease gun. Grease this bearing twice each bag,
two pumps at the beginning of the bag and two pumps
halfway through the bag. Do not over grease. It is bet-
ter to give the bearings smaller amounts of grease more
often, than large amounts of grease.
RAIL16GEN0175AA
4
7-46