8 APPLICATION INSTRUCTION
8.17 Pulse Related Instruction
589
8
■
Applicable devices
*1 When a bit device is specified, specify one of X0 to X17.
Only X can be used for a bit device.
The nibble of a bit device cannot be specified.
*2 When a word device is specified, specify one of the channel numbers (CH1 to CH8).
When FX3 compatible function of a high-speed counter is valid, a channel number cannot be specified. Only X can be used for a bit
device.
If the channel numbers is specified in (s1), an error occurs.
Processing details
• This instruction counts the number of times the device input specified by (s1) turns off
on only for the time (in 16-bit data
units) specified by (s2)
1ms and stores the operation result in the device specified by (d).
• The channel number of the high-speed counter specified by (s1) interlocks with the channel number in which parameters
are set.
• When a word device is specified by (s1), this instruction counts the number of pulses by the high-speed counter setting of
the channel number corresponding to each word device.
• When a bit device is specified by (s1), the following input assignment devices (shaded area) are valid.
• When the high-speed counter FX3 compatibility function is enabled, only the 1-phase 1-input pulse input mode (S/W)
(general-purpose input assignment of the 1-phase 1-input counter (switching S/W up or down)) is enabled.
General-purpose input assignment of the 1-phase 1-input counter (switching S/W up or down)
Operand
Bit
Word
Double word Indirect
specification
Constant
Others
X, Y, M, L, SM,
F, B, SB, S
T, ST, C, D, W,
SD, SW, R
U
\G
Z
LC
LZ
K, H
E
$
(s1)
(s2)
(d)
(1): The elapsed time is judged using the 1ms interrupt and the counted result is stored in (d).
U/D: UP/DOWN pulse input, P: Preset input (reset), E: Enable input (start)
If one of X10 to X17 is specified as a device, an error occurs.
ON
OFF
OFF
(s2)ms
(s2)ms
ON
(s1)
(1)
(1)
Counting start
Execution
command
U/D(A)
U/D(A)
U/D(A)
U/D(A)
P
E
U/D(A)
U/D(A)
U/D(A)
U/D(A)
P
E
P
E
P
E
P
E
P
E
P
E
P
E
X0 X1 X2 X3 X4 X5 X6 X7 X10
X11
X12
X13
X14
X15
X16
X17
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
Summary of Contents for MELSEC iQ-F FX5
