346
7 BASIC INSTRUCTIONS
7.6 Digital Switch (Thumbwheel Input)
Processing details
The value of each digital switch connected to (s) is input by the time division method (in which the value is input in turn from
the 1st digit by 100 ms interval output signal), and stored to (d2). A numeric value from 0 to 9999 (up to 4 digits) can be read,
the first set is stored to (d2), and the second set is stored to (d2)+1.
When using one set of 4 digits (n = K1)
A 4-digit BCD digital switch connected to (s) to (s)+3 is read in turn by the strobe signal (d1) to (d1)+3, and stored in binary
format to (d2).
When using two sets of 4 digits (n = K2)
A 4-digit BCD digital switch connected to (s) to (s)+3 is read in turn by the strobe signal (d1) to (d1)+3. (s) to (s3)+3 is stored
in (d2) and (s)+4 to (s)+7 is stored in (d2)+1 as BIN format.
For the connection example of digital switch, refer to the following manual.
MELSEC iQ-F FX5U User's Manual (Hardware)
MELSEC iQ-F FX5UC User's Manual (Hardware)
Precautions
• Though the contents of (d2) do not change, all of (d1) to (d1)+3 turn OFF.
• When one set of 4 digits (n = K1) are used, four devices are occupied starting from (s).
• When two sets of 4 digits (n = K2) are used, eight devices are occupied starting from (s), and two devices are occupied
starting from (d2).
• When connecting a digital switch of less than 4 digits, it is not necessary to wire the strobe signal (output for digit
specification) (d1) to unused digits. Because unused digits are occupied also by this instruction, however, they cannot be
used for any other purpose.
• For continuously receiving digital switch values, make sure to use a transistor output type CPU module.
• Use BCD output type digital switches.
• The DSW instruction can only be executed four times in a program.
Operation error
Error code
(SD0/SD8067)
Description
2820H
The device range specified by (s), (d1), (d2) exceeds the corresponding device range.
3405H
(n) is other than 1 or 2.
The value specified by (s) to (s)+1 and (s)+4 to (s)+7 is other than 0 to 9.
1811H
The number of the DSW instructions which are used simultaneously exceeds four.
Summary of Contents for MELSEC iQ-F FX5
