Yamaha WR426F(P), Руководство по эксплуатации для владельца

Страница: 714 / 776

6 - 10
– +
ELEC
TPS (THROTTLE POSITION SENSOR) SYSTEM
4. Adjust:
●
Idle speed
5. Insert the thin electric conductors 2
(lead) into the TPS coupler 1 , as shown,
and connect the tester to them.
CAUTION:
●
Do not insert the electric conductors
more than required because it may
reduce the waterproof function of the
coupler.
●
Make sure that a short-circuit dose not
develop between the terminals because it
may cause damage to electrical compo-
nents.
Adjustment steps:
●
Attach the inductive tachometer (engine
tachometer) to the high tension cord.
●
Turn the throttle stop screw 1 until the
specified idle speed.
Refer to “IDLE SPEED ADJUSTMENT”
section in the CHAPTER 3.
Idle speed:
1,700 ~ 1,900 r/min
Tester (+) lead
→
Yellow lead 3
Tester (–) lead
→
Black lead 4
6. Start the engine.
7. Adjust:
●
TPS output voltage
Adjustment steps:
Adjust the installation angle of the TPS
1
to
obtain the specified output voltage.
NOTE:
Measure the output voltage accurately with
a digital electronic voltmeter that gives an
easy reading of a small voltage.
TPS output
voltage
Tester selector
position
0.58 ~ 0.78 V DCV