Yamaha WR426F(P), Руководство по эксплуатации для владельца

Страница: 298 / 776

3 - 29
INSP
ADJ
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
●
Loosen the pad pin 2 .
●
Remove the brake hose holder
3
and cal-
iper 4 from the front fork.
●
Remove the pad pin and brake pads 5 .
●
Connect the transparent hose 6 to the
bleed screw
7
and place the suitable con-
tainer under its end.
●
Loosen the bleed screw and push the cali-
per piston in.
CAUTION:
Do not reuse the drained brake fluid.
●
Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
●
Install the brake pads 8 and pad pin.
NOTE:
●
Install the brake pads with their projections
a
into the caliper recesses
b
.
●
Temporarily tighten the pad pin at this
point.
●
Install the brake hose holder 9 and cali-
per 0 and tighten the pad pin A .
NOTE:
Fit the brake hose holder cut
c
over the
projection
d
on the front fork and clamp the
brake hose.
T
R
.
.
Bolt (caliper):
23 Nm (2.3 m • kg, 17 ft • lb)
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)