Yamaha WR426F(P), Руководство по эксплуатации для владельца

Страница: 222 / 776

2 - 39
SPEC
CABLE ROUTING DIAGRAM
È
Make sure that the TPS read
coupler does not go outside
the chassis.
Ô
Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.

Pass the carburetor breather
hoses and overflow hose
between the connecting rod
and cross tube (frame).
Ò
Fasten the neutral switch lead
and oil hose together with a
plastic locking tie and cut off
the tie end.
˜
Fasten the cylinder head
breather hose with the hose
holder.
ˆ
Fasten the neutral switch lead
to the frame with a plastic
band ends toward the rear of
the frame.
Ø
Fasten the neutral switch lead
and CDI magneto lead
together with a plastic band.
∏
Pass the clutch cable through
the cable guide.
Œ
Pass the cylinder head
breather hose along the inner
side of the radiator pipe.
Â
Pass the clutch cable between
the frame and radiator and
over the lower boss on the
radiator.
Í
Pass the neutral switch lead
and CDI magneto lead through
the cable guide and over the
middle radiator mounting boss.
Then, pass the decompression
cable under the middle radia-
tor mounting boss and along
the left side of the neutral
switch lead and CDI magneto
lead.
Ê
Pass the clutch cable through
the cable guide.
Ë
Fit the brake hose into the
guides on the protector.
◊
Fasten the ignition coil lead
(in the sub wire harness) on
the upper inside of the frame
and cut off the tie end.
„
Pass the ignition coil lead (in
the sub wire harness) under
the cushion bracket (frame).
≈
Fasten the ignition coil lead
(in the sub wire harness) to
the frame with a plastic lock-
ing tie and cut off the tie end.
Á
Pass the carburetor breather
hoses, overflow hose and
coolant reservoir tank
breather hose so that all there
hoses do not contact the rear
shock absorber.