Viavi T-BERD MTS 5800, Руководство по началу работы

Страница: 142 / 296

Chapter 4 Basic Testing
Step 5: Viewing test results
T-BERD/MTS/SC Getting Started Guide
Page 118 22046537, Rev. 016 March 2018
Stopping a test
When you stop a test, test results immediately stop accumulating, but remain on the
display until you start the test again.
To stop a test
• Press the START/STOP button.
The test stops. To start the test again, you must press the START/STOP button.
Step 5: Viewing test results
Test results appear in the Results Windows of the Main screen.
Setting the result group and category
To set the result group and category
1 Using the Test menu or Quick Launch screen, select a test application see “Step
1: Selecting a test application” on page 109 ), and then configure your test (see
“Step 2: Configuring a test” on page 113 ).
2 Select the Results soft key to return to the Main screen.
3 Connect your module to the circuit. For details, refer to the testing manual for the
circuit you are connecting to.
4 If you are testing an optical interface, select the Laser button.
5 If you selected an Ethernet, Fibre Channel, or SONET/SDH GFP test application,
select the
Start Traffic button to start generating and analyzing traffic.
Results appear in the Results Windows.
6 Optional . Insert errors or anomalies into the traffic stream, or use the Action
buttons to perform other actions. These buttons only appear if applicable to your
test application.
7 Use the Group and Category buttons to specify the type of results you want to
observe.
Figure 68 illustrates buttons for a standard SONET application.
NOTE:
If you scheduled a timed test, the test stops automatically after running for the
duration you specified.
Figure 68 Result Group and Category buttons