Thermo Scientific 43i, Инструкция по эксплуатации

Страница: 280 / 312

C-Link Protocol Commands
I/O Configuration
B-40 Model 43 i Trace Level-Enhanced Instruction Manual Thermo Fisher Scientific
Send: set analog vout range 2 3
Receive: set analog vout range 2 3 ok
Table B–11. Analog Voltage Output Range Values
Range
Output Range
1 0-1 V
2 0-100 mV
3 0-10 V
4 0-5 V
0 [cannot be set to this, but may report] Undefined
dig in
This command reports the status of the digital inputs as a 4-digit
hexadecimal string with the most significant bit (MSB) being input 16.
Send: dig in
Receive: dig in 0xff7f
din channel
This command reports the action assigned to input channel and the
corresponding active state. The example that follows reports the input 1 to
be assigned an index number 3 corresponding to action of SO
2
mode with
the active state being high.
Send: din 1
Receive: din 1 3 SO2 MODE high
set din channel index state
This command assigns digital input channel (1-16) to activate the action
indicated by index (1-35), when the input transitions to the designated state
(high or low). Use “list din var” command to obtain the list of supported
index values and corresponding actions.
Send: set din 5 9 high
Receive: set din 1 9 high ok
dout channel
This command reports the index number and output variable and the
active state assigned to output
channel. The example that follows reports
the input 4 to be assigned an index number 11 corresponding to general
alarm with the active state being open.