Thermo Scientific 43i, Инструкция по эксплуатации

Страница: 172 / 312

Servicing
7-8 Model 43i Trace Level-Enhanced Instruction Manual Thermo Fisher Scientific
5. Disconnect the connectors that pass through the center of the partition
panel.
6. Remove two screws from the left side of the case (viewed from front).
7. Remove one screw from the bottom rear of the case.
8. Remove one screw from the top front of the partition panel.
9. While holding the case securely, loosen the captive screw at the rear of
the measurement bench, and pull the measurement bench from the rear
of the case.
10. Remove the screw at the top rear of the partition panel securing the top
of partition panel to the measurement bench, and lower the panel being
careful not to put excessive tension on the cables.
11. Replace the measurement bench by following previous steps in reverse.
Use the following procedure to replace the fuse.
Equipment Required:
Replacement fuses (refer to the “Replacement Parts List” in this
chapter).
1. Turn instrument OFF and unplug the power cord.
2. Remove fuse drawer, located on the AC power connector.
3. If either fuse is blown, replace both fuses.
4. Insert fuse drawer and reconnect power cord.
Use the following procedure to replace the pump ( Figure 7–4 ). To rebuild
the pump, see “Pump Rebuilding” in the “Preventive Maintenance”
chapter.
Equipment Required:
Fuse
Replacement
Pump
Replacement