Thermo Scientific 43i, Инструкция по эксплуатации

Страница: 279 / 312

C-Link Protocol Commands
I/O Configuration
Thermo Fisher Scientific Model 43 i Trace Level-Enhanced Instruction Manual B-39
to Table B–10 . This command responds with “feature not enabled” if the
I/O expansion board is not detected.
Send: analog iout range 4
Receive: analog iout range 4 2
set analog iout range channel range
This command sets analog current output channel to the channel range
where channel is between 1 and 6 inclusive, and range is set according to
Table B–10 . The example that follows sets current output channel 4 to the
0-20 mA range. This command responds with “feature not enabled” if the
I/O expansion board is not detected.
Send: set analog iout range 4 1
Receive: set analog iout range 4 1 ok
Table B–10. Analog Current Output Range Values
Range
Output Range
1 0-20 mA
2 4-20 mA
0 [cannot be set to this, but may report] Undefined
analog vin channel
This command retrieves the analog voltage input channel data, both the
calculated value and the actual voltage. In the example that follows, the
“calculated” value of channel 1 is 75.325 degrees F, volts are 2.796. This
command responds with “feature not enabled” if the I/O expansion board
is not detected.
Send: analog vin 1
Receive: analog vin 1 75.325 2.796
analog vout range channel
This command reports the analog voltage output channel range, where
channel is between 1 and 6 inclusive, according to Table B-11.
Send: analog vout range 2
Receive: analog vout range 2 3
set analog vout range channel range
This command sets analog voltage output channel to the range, where
channel is between 1 and 6 inclusive, and range is set according to Table B–
11
. The example that follows sets channel 2 to the 0-10 V range.