Thermo Scientific 43i, Инструкция по эксплуатации

Страница: 254 / 312

C-Link Protocol Commands
Diagnostics
B-14 Model 43 i Trace Level-Enhanced Instruction Manual Thermo Fisher Scientific
Send: alarm trig conc so2
Receive: alarm trig conc so2 1
These commands set the SO
2
concentration alarm minimum value, where
value is set to either floor or ceiling, according to Table B–3 . The example
that follows sets the SO
2
concentration minimum alarm trigger to ceiling.
Send: set alarm trig conc so2 1
Receive: set alarm trig conc so2 1 ok
Table B–3. Alarm Trigger Values
Value
Alarm Trigger
Value
00 Floor 00
01 Ceiling 01
agc int
This command reports the current of the reference channel AGC circuit.
The example that follows reports that the current AGC intensity is 90
percent.
Send: agc int
Receive: agc int 90 %
diag volt mb
This command reports the diagnostic voltage measurements on the
motherboard. The sequence of voltages is: Positive 24, positive 15, positive
5, positive 3.3, and negative 3.3. Each voltage value is separated by a space.
Send: diag volt mb
Receive: diag volt mb 24.1 14.9 4.9 3.2 -3.2
diag volt mib
This command reports the diagnostic voltage measurements on the
measurement interface board. The sequence of voltages is: Positive 24,
positive 15, negative 15, positive 5, and positive 3.3. Each voltage value is
separated by a space.
Send: diag volt mib
Receive: diag volt mib 24.1 14.9 -14.9 4.9 3.2
Diagnostics